0
$\begingroup$

Does the Bevel Tool only evenly Bevel if the object is a pure cube or square?

My Bevel Tool currently only cuts into one face, at a sort of 5-1 ratio rather than an even spread.

In this example, I want the bevel to 'corner off' the, well, corner. As marked in red.

I'm a newish modeller and it's possible some settings are scrambled or something.

Thanks!

enter image description here

$\endgroup$

marked as duplicate by Duarte Farrajota Ramos Jul 1 at 10:34

This question has been asked before and already has an answer. If those answers do not fully address your question, please ask a new question.

0
$\begingroup$

You have a couple of coincident edges.

If you start with an edge close to the corner, the bevel will be clamped on one side (left and middle, below). If the edge is slid all the way down so you can't see it, the bevel will only happen on one side (right).

enter image description here

Note, if you're in Face selection mode, and you have face markers switched on, you can see the scrunched face .. it's the dot in the middle of the corner edge.

Solution: Remove doubles (2.79: CtrlV,R. 2.8: AltM Merge > 'By Distance')

$\endgroup$

Not the answer you're looking for? Browse other questions tagged or ask your own question.