1
$\begingroup$

enter image description here

In the picture above I have two feet. The blue one is the one I have selected and gone into weight paint mode. I'm trying to change some vertices to red in weight paint mode but don't really understand how to do this. When I use the brush on the foot, nothing happens. It simply remains blue. It also doesn't show me vertices. It appears solid. If I enable wire frame mode, it shows all the vertices but doesn't allow for selecting certain vertices.

How can I paint specific vertices along the seam of my foot red?

Improve this question
$\endgroup$

1 Answer 1

Reset to default
3
$\begingroup$

In your screenshot the weight and radius of your brush are set to 0, and you are using the subtract brush.

If you set them to higher values and pick a brush like mix, then it should work:

enter image description here

Improve this answer
$\endgroup$
3
  • 2
    $\begingroup$ Also make sure you are using the correct brush. $\endgroup$
    – Steve Hunt
    Commented Jul 26, 2014 at 2:12
  • $\begingroup$ Thank you. It works exactly as expected with the right brush. I had to put the radius to 9 and zoom in or it grabbed too many vertices. Thank you both! <3 $\endgroup$
    – Candice
    Commented Jul 26, 2014 at 2:23
  • $\begingroup$ @SteveHunt Good point, added $\endgroup$
    – gandalf3
    Commented Jul 26, 2014 at 2:31

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .