0
$\begingroup$

I trying to do my second full project after finishing Chris Plush's Pretzel. So I am on to Blenderguru's anvil and have I stalled. Cutting the circular slots with a cylinder into the anvil built from a plane has been terrible. My problem is after I finish the the boolean modifier. Because of the model design I need to go inside of the newly cut circular semi-circle and line up the new vertical edges with the preexisting horizontal edges. Now I have my anvil with 2 semi-circular cuts in the base with all the geometry lined up and I go to apply the Subsurface and disaster. The bottom layer of the geometry is gathering together in the middle of the center of the 2 semi-circles. I have tried this with a miroir, using the loopcut to divide the mesh before the modifier and after the modifier. I have done it without a mirror and just did 2 cuts and still the same problem.Does anybody have any suggestions on what might be happening to the bottom layer of geometry? Thanks Wayne

enter image description here

enter image description here

$\endgroup$
3

0

Browse other questions tagged .