0
$\begingroup$

I want to join two sides of an object. 1. I used Knife Project to mark both sides of the object with a circle.

2.Then I deleted the marked faces.

  1. I selected the edges of the hole created from the one side

  2. I turned on the magnet

  3. I extruded along the Y axis. But I cannot get it to snap the the vertices on the opposite side of the object.

$\endgroup$
0
$\begingroup$

Although not 100% sure, I believe 1. I need to press and hold the Ctrl key while extruding. 2. I set the snap to option to Closest 3. I set the pivot point to active element

  1. I did turn on "Automatically merge vertices moved to same location". However, when I checked afterwards by clicking the remove doubles, 56 doubles were still removed. So not sure how that is suppose to work.
|improve this answer|||||
$\endgroup$

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.