enter image description here

I want to add some wrinkles on the side faces of the lid like the left image

I'm a beginner so detailed explanation would be much appreciated. Thank you.

  • $\begingroup$ Thats a similar problem to this one, the suggestions there should help. $\endgroup$
    – sambler
    Aug 22, 2018 at 5:29

1 Answer 1


Checker Deselect

  • If you want your lid to stay flat, so you can put a nice bevel on it, extrude the cylinder's cap-poly first. This will create a circular loop to hold that edge.

  • Get enough separations in the side of the cylinder to hold your detail.

  • Select the parts you want to push in, the "valleys". If you have a lot of those, after selecting the whole row of edges, use Mesh > Checker Deselect to get the pattern of selection, that you want

  • Shrink/Fatten the faces in or out (Alt + S)or Extrude them into or out of the cylinder (E) by using Individual Origin as the Pivot Point.


You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .