2
$\begingroup$

enter image description here

I want to add some wrinkles on the side faces of the lid like the left image

I'm a beginner so detailed explanation would be much appreciated. Thank you.

$\endgroup$
1
  • $\begingroup$ Thats a similar problem to this one, the suggestions there should help. $\endgroup$
    – sambler
    Aug 22, 2018 at 5:29

1 Answer 1

4
$\begingroup$

Checker Deselect

  • If you want your lid to stay flat, so you can put a nice bevel on it, extrude the cylinder's cap-poly first. This will create a circular loop to hold that edge.

  • Get enough separations in the side of the cylinder to hold your detail.

  • Select the parts you want to push in, the "valleys". If you have a lot of those, after selecting the whole row of edges, use Mesh > Checker Deselect to get the pattern of selection, that you want

  • Shrink/Fatten the faces in or out (Alt + S)or Extrude them into or out of the cylinder (E) by using Individual Origin as the Pivot Point.

$\endgroup$

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .