0
$\begingroup$

I'm trying to use a loop cut so that I can extrude a specific part of my mesh. Problem is: When I use loop cut, it doesn't go all the way trough, show in the image.

How can I fix this? Thanks in advance enter image description here

$\endgroup$
3
  • 3
    $\begingroup$ There probably are N-gons that are stopping the edgeflow. Did you inspectd the faces nearby the edgecut? $\endgroup$
    – Carlo
    Aug 20, 2018 at 22:29
  • $\begingroup$ yes or some inner faces $\endgroup$
    – moonboots
    Aug 21, 2018 at 4:00
  • $\begingroup$ @moonboots inner faces were the issue. Thanks a lot ! $\endgroup$ Aug 21, 2018 at 7:57

1 Answer 1

0
$\begingroup$

You must have inner faces. Delete them, otherwise Blender doesn't know where to extend the loop cut.

$\endgroup$

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .