Hi I got a Cube and a Cylinder. What is the fastest way (minimal steps) to move the Cylinder, so the center of the bottom face of the Cylinder will snap to the center of top face of the Cube ?
2 1/2 Steps
In Object Mode, With Pivot set to 'Active Element', Manipulate Center Points switched On, Snap Off, but set to 'Face' and 'Closest'..
- Select Cylinder, then Cube, and S,ShiftZ,0
- If the bottom of the cylinder isn't close to the top of the cube, GZ until it is.
- CtrlGZ to snap the bottom of Cylinder to the top of Cube.