When I use quick smoke to create a smoke simulation everything works fine,
but when I create a box and make it a domain, the smoke simulation is not visible in the render due to visible domain?
What's causing this?
$\begingroup$
$\endgroup$
5
-
1$\begingroup$ Please make your question clearer. Please show the settings for the manual domain. A domain can remain a box before the simulation starts. $\endgroup$– atomicbezierslingerCommented Jul 27, 2018 at 7:14
-
$\begingroup$ In the past there was problem with having more than one domain with a bake. $\endgroup$– atomicbezierslingerCommented Jul 27, 2018 at 7:15
-
$\begingroup$ Only one domain in the scene at a time, domain settings default... when I make a box a domain manually it just doesn't show the smoke in the render $\endgroup$– Mateusz SowińskiCommented Jul 27, 2018 at 7:22
-
1$\begingroup$ You have not yet shown your settings. Screen Capture. You might even have an extra box. Did you Bake? $\endgroup$– atomicbezierslingerCommented Jul 27, 2018 at 7:24
-
2$\begingroup$ What material have you assigned to the domain? Is it a volumetric or just a surface shader? The Quick Smoke does more than just create the domain - it also assigns a volumetric material to it. $\endgroup$– Rich SedmanCommented Jul 27, 2018 at 8:01
Add a comment
|
1 Answer
$\begingroup$
$\endgroup$
That's because the default material for the domain is still enabled 
so you see on that image that it doesn't work
so you have to make a random image and apply quick smoke on it and then delete it and then select the domain again and choose the smoke domain material 
and then it works.
