0
$\begingroup$

i have made the verts and extruded and added cloth simulation and below a plane ground. Why the verts not lay down on the ground. I have apply passive from physics tab.

enter image description here

New Result enter image description here

$\endgroup$
  • $\begingroup$ Please edit your question to add some explanation as to what those images show and what steps you've taken to get to where you are now. Show screenshots of any relevant settings along with explanations where you can, describe what geometry you have in each example, what collision settings, anything else that is relevant. $\endgroup$ – Rich Sedman May 22 '18 at 21:03
  • $\begingroup$ @RichSedman A suggestion given by thibsert i have turn floor to collision and cloth (a verts line) i have extruded to 0.005 and got the above result (new result). Nothing special in the cloth setting. Just self collision on thats it. Rest default setting. $\endgroup$ – atek May 23 '18 at 3:32
4
$\begingroup$

Floor plane needs to be set as Collision, not Rigid Body.

Cloth needs Faces to work, not only verts. You should extrude your vertices by a small amount on Y. (Not to small : below 0.003 I had some strange results)

$\endgroup$
  • 2
    $\begingroup$ Good point about Cloth needing Faces. If it is really a requirement to have edges only then Soft Body might be a better fit. $\endgroup$ – Rich Sedman May 22 '18 at 11:16
  • $\begingroup$ The verts made as shown but its not landing on the floor or ground and verts getting stretch behind. Not like a thread its smoothly fall down $\endgroup$ – atek May 22 '18 at 12:01
  • $\begingroup$ i have attach new gif file new result. Its not landing on the floor and scrolling behind $\endgroup$ – atek May 22 '18 at 12:07
  • $\begingroup$ @RichSedman plz look at the result as mention in the answer. gif file attach in the question (new result) $\endgroup$ – atek May 22 '18 at 12:08
  • $\begingroup$ @atek, it's not clear what you've changed to get the 'new result'. Please update your question with step by step results to how someone could set up the same situation. Any new info should ideally be in the original question rather than tagged on as comments to this answer. $\endgroup$ – Rich Sedman May 22 '18 at 12:23

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.