# Locking size of individual mesh part

I have an object with a lot of holes with the same size.

I want to make the object smaller, but also I want to save sizes of the holes that are part of the object.

• Screenshots? It is hard to tell what you're asking with just words. Apr 26 '18 at 23:42
• imgur.com/a/WkHtzDf Apr 26 '18 at 23:48
• I went ahead and edited your question for you to add the screenshot. Apr 27 '18 at 0:01

After scaling the object, determine the amount of scaling of the holes required to "undo" that scaling. For example, if the object was scaled down by a factor of 0.9, use 1 / 0.9 = 1.111 as the scale factor to adjust the holes by.