0
$\begingroup$

I'd like to extrude these faces toward the center of the shape equally - say a 5cm. Try as I might, I can't figure it out. Lots of solutions show inset for faces, but this is just a shape of vertices. There must be a way. I'm in 2.8

enter image description here

Improve this question
$\endgroup$
2
  • $\begingroup$ Extrude and scaling inside should do the trick $\endgroup$
    – Jorge Manuel Bello
    Commented Apr 22, 2019 at 18:05
  • $\begingroup$ Lots of solutions propose filling in a face because that's the simplest and effective way to create row of vertices connected to original while preserving the shape as much as possible without using addons. Other than that there's Offset edges addon which probably might be doing what you ask $\endgroup$
    – Mr Zak
    Commented Apr 22, 2019 at 23:13

1 Answer 1

Reset to default
2
$\begingroup$

The way I do this is by selecting all the vertices and making a NGon by pressing F. Then I use inset and delete the innermost face.

Improve this answer
$\endgroup$

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .