3
$\begingroup$

I'm trying to change the height of an inset extrusion on a block mesh, but the object is distorting when I attempt to change the height. Below is a snap of two block meshes. Each has an inset of the top face, and an extrusion of the inner face. One is up, the other down.

I can change the right object's top face (G then Z for the height), with no distortion to the cube. However when I change the left cube's lower face the entire cube distorts. I need to do small adjustments to the inner surface depth only.

Before enter image description here

After enter image description here

$\endgroup$
1

1 Answer 1

3
$\begingroup$

You have proportional editing (O) enabled:

enter image description here

Disable it by pressing O again or selecting disabled in 3D view > Header.

$\endgroup$
0

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .