after managing to get the mesh to follow the bezier circle theres a problem where it twists and screws up in one corner but the other corner seems fine. if it matters the origin point is at the top of the curve.
$\begingroup$
$\endgroup$
1
asked Oct 6, 2018 at 4:24
-
$\begingroup$ perhaps you could fix it with tilt (ctrl T or in the N panel > Transform)? If not, could you share your file? $\endgroup$– moonbootsOct 6, 2018 at 8:49
Add a comment
|
1 Answer
$\begingroup$
$\endgroup$
Add a subsurf modifier to both curve and the mesh.
Select the Curve in edit mode -> Tooshelf -> curve tools -> Switch Direction
If there is a gap seen in the mesh go to edit mode and scale in Z axis.
